For shits and giggles, if you already didnt start to button it up, measure continuity from the ground screw to exactly where you got shocked.
2 Likes
If you ran that light with the top off it would prob last quite a bit longer.
I would dissipate the heat better and be a little more efficient and also extend the life of the drivers and LED’s.
Obviously have to be modified a little tho.
1 Like
I got shocked from the hanger.
I just tested the yellow wire inside an the outside of all the copper pieces that the hanger mounts to
Two out of the four were beeping. I don’t know what that means but I hope it’s good lol
Final call? Might as well button her back up.
Get set-up with the voltmeter. Let us know when you are ready.
3 Likes
I’m callin it a day. I’ll put it all back together tomorrow an plug it in an turn it on an cross my fingers.
Hope all goes well… I’ll reply once I do. Thanks again for everyone’s knowledge. Would have never gotten this far without you guys 
3 Likes
The 2 that didnt beep are not grounded, maybe try tighten the hanger mounts or there maybe too much paint to allow for a good ground.
It wont fix the the problem but might prevent further shocks.
1 Like
I will try an tighten them later today thanks @wolfedawwg