You’re right @eskobar and I might add, taking habits from RW/dome cloning don’t die hard. It’s far more easy to be laxed with that method, so consecutive runs drop in rates… you’ve definitely added a lot of good info to this aero cloning compendium.
Anyway, after 4 days cycling 30 ml bleach
. I dumped. I didn’t rinse, and air dried for a day. After removing old tarps that block accidental sprays from electronics/outlet and putting in new tarp, I brought in the cloner. Sprayed down w Oxine 1 drop 32 oz dilution. Wiped off. Then Physan 20 1 drop at 20 oz dilution (both RO) I had previously boiled 1 gall and chilled it, so it sat while I sanitized the entire area where cloner is. I decided to do it again, but just near that point. 1 drop of Oxine per 32 oz. With the water ready and cycling. I make a small glass of RO water and a drop of rez clear. I take my shears and mist spray Physan on them. I’ve taken 2 test cuts, into the glass. I have a glass baking dish. Pour the RO water. Wait 2-3 mins, submerge stems ends, cut, remove the stipule and knots then scrape lightly. 20 ml of Hormex and nothing else added. Put the dome on. No timer. After I’m done I’m spray the Physan all around me and all the tools/products, outside of the lid/dome. Even though this area is at the edge of a rug, I spray around and down this entire area as I’m walking away. Gloves off. I’m done
Let’s see if all these adjustments prove to be the real solution
