So, dear community, this is my first attempt with mapito. I have been doing a lot of theory lessons now, so it’s time to put it into practice.
I have an ebb and flow system. I have been using mapito until the pH value of the substrate was 5.6.
Now I put all the pots in their place and flood my table with water, pH value 5.6. And when the waste water is no more than 5.8, I fill my tank, heat the water to 24 degrees Celsius and add enzymes and roots. Then I flood it again so that my substrate reaches 24 degrees Celsius. By then my cuttings will have roots. I plant the cuttings and water them with the water from the tank… And then I just flood it…
I would be happy to receive suggestions, tips and support…
I hope you have a nice day
10 Likes
Your flush procedure sounds fine.
Little confused with the temperature/enzyme stuff but I’m just not familiar with them
2 Likes
Nice. Keep sharing the updates. I wanna know more about Mapito ebb flow grows.
1 Like