Update:
Day 70.
Freakshow: 3 females and 2 males.
They have started flowering, but they are small and have returned to the refrigerator.
Sativa Drean: It started flowering too, it went back to the fridge.
I’m going to revegetate for cloning.
At the bottom, some clones of Brazilian sativa. I still haven’t been able to make clones, I hope to be successful.
Perhaps you should change the cloning technique 
, if they are too big they have too many big fans to feed and support, you could try this one, works for me … 
Thank you, @George1961.
Vermiculite and perlite arrived,
I made 3 clones in perlite, 3 in vermiculite and one in a mixture of these. If not successful, I will order the pellets.
I believe the variety is difficult to pick up, it’s the Brazilian sativa.
The hybrids get good, just sticking in the ground… After a few days they take root…
Looking good as always @Gugumelo! @Floyd has an awesome technique for cloning. I don’t know what post it’s on or I would link it. Maybe Floyd could stop by.
Here’s the link. Lots of ways of making one. But this is how I made mine. 
success rate
My homemade bubble cloner
Morning folks!!! Yes @Gugumelo, like @corey said, @Floyd’s cloner is one to be followed. I’m in the process, as you can see below, still have to get air pump and stones… Looks like 100% efficacy! A shout out to Floyd!!!
Did the lid crack when you drilled your holes. A block of wood under where your drilling will help with that, or run your drill in reverse when you drill.
The duct tape. 
@Floyd Yep, my mishandling shows duct tape to cover for my mistakes…lol! The other obvious problem is that the plastic is kinda low grade, it was cracking a bit too easily, to be honest. I thought of going ahead and replacing it eventually, if I felt the need. Lately, my debate would be whether getting to strips of stones (can’t find the bigger, circular ones you got here) or two sets of 5 valves in each. Thanks!
