unless both is an option, cob gets my vote
Going flyweight…
It was fun building the alum frames, but not using them for this phase.
Willing to risk adhesive failure in my lil hobby grow. I have screws if they screw with me.
11"x22"
All 20 strips - 3.5k 80cri
Also decided to stick with CMH/LED strip combo.
315w cmh
260w ± led
I have another spot for the COBettes.
Both - I like the way you think.
Considered CMH surrounded by 4 of the COBs. But then I got bit by boredom and the led strip bug.
Layout planning…
Boring.
Will use a Philips 3k bulb.
All remote mounted ballast.
Behind the foam panel is fresh air intake from lung room. (20x30 Merv13 filter)
Bottom left hole is veg box active intake vent
what about 2 cobs on both sides of the cmh?
Was there any noticeable difference between the buds under Cmh , under the cobs and in the overlap ?
Not really. But I have never grown under only COBs.
Way too many variables, mostly self induced
Forget the garden stakes.
Found these awesome 4ft fiberglass “posts” at Tractor Supply. $1.49 each. (Smooth surface unlike the green garden stakes.)
the dimmer [POTS] wires don’t need to be solid core or low AWG since they don’t carry much current back to the driver…
Dial-a-Watt. Have foam board will cobble. Lol
Different pots/dials. A 10-turn and standard 1-turn. Both 100ohmeys.
All the wiring will be redone once I figure out where I’m mounting everything.
Do you simply x-acto knife your foam board or melt? Very clean lines!
Yes, very similar to an exacto.
Snap-off blade from my window tinting hobby.
https://www.amazon.com/gp/aw/d/B003DXWN42/ref=psdcmw_553240_t3_B0006Q9CMK?th=1&psc=1
https://www.amazon.com/gp/aw/d/B01MG2D9K7/ref=sspa_mw_detail_4?ie=UTF8&psc=1
I also did some melting of the foam by heating up a metal screwdriver.
Dang. Only enuff wallpaper on the roll for the left side.
When I first built the veg room, had to install film on back wall to prevent light leakage between veg and flower. Never finished wallpapering.