I used commercial 30 ppm in the past and it was a total failure mate. Why don’t you just generate your own??
CS_Generator.pdf (875.3 KB)
2 Likes
I would prefer to buy…then at least if it doesnt work, I can be pissed off at the product rather than myself. Lol
Gonna put the order through for the 500ppm. It comes with a dropper instead of sprayer head. Figure I’ll just put a drop every 8 hours on the top I want to produce pollen. 500 ppm should either work or burn the ish out of it I assume.
1 Like
500 ppm will burn the shit out of them mate. I’d go no higher than 100 ppm unless you dilute the 500ppm solution down with distilled water 
2 Likes
That works out well then…I can dilute and get 10x the solution! 10:1 would bring it down from 500 ppm to 50 ppm…yeah?
1 Like
I tried the “500” ppm until I ran out. I ended up making my own with 9 volts. Leave it for a bunch of hours and giver. With the 500 ppm stuff my first plant took over 20 days. My latest was growing balls in 8 days
3 Likes
And not really any signs of burning from either stuff I’ve used.
2 Likes
Where do I get silver wire? Can I use some of my granny’s old silver cutlery?
And the 9 volt method…I imagine it’s just 9 volt battery, wire to +, wire to - and place in distilled water?..not the whole battery, just the wire
1 Like
honestly make your own, and yeah if the cutlery is 99.9% silver you can use it she may kill you though, i personally just bought a 1oz bar and cut it in half.
Also you can use pretty much any wall wort that puts out low dc voltage and amperage, i was using a bit higher voltage transformer “22v dc” but have switched to using just a stripped back usb cable and a standard usb charger…
And yes distilled water, first go takes longer, but on subsequent batches just mix in a little of the old batch as your water conductivity will be better.
5 Likes
Are these good enough? Small, but they’ll do?
1 Like
I bought a 1 oz silver bar aswell and then just connected three 9 volts post to post (like a pyramid). I believe the 1 oz bar was like 30 canadian from a local gold/silver seller
2 Likes
I fired up my hi tech blueprint program to make you a diagram lol. Make sure you keep anything non silver out of the water, and dont let em touch each other.
5 Likes
You can re purpose an old 12v power supply add crocodile clips to both the positive and negative. Put a piece of .999 silver on each clip and you have a colloidal silver generator. They say to use distilled water but I’ve found water from my dehumidifier reads 0ppm so I just use that and it works perfectly well
2 Likes
Making some calls now…seems cheaper than amazon.
2 Likes
Lady said about $26 for an ounce…lol…cheaper than weed.
3 Likes
Fuckin’ picasso over here…lol
3 Likes
I’m basically a professional blue print designer
4 Likes
Would you believe me if I said I did that free hand without fancy software?
1 Like
old picture of mine that’s already uploaded here, of the super high tech generator
6 Likes
That is way better than my hillbilly creation lol. I was too cheap to buy 9v connectors for the wires so I hot glued and duct taped them onto the terminals and backed away slowly…
How many volts is the adapter? I keep meaning to use the power supply I’ve got, adjustable voltage and amperage, ac or dc aswell
2 Likes
well that one was 22v at 0.4a old thomson modem power adapter, but like i said above i have since gone to a stripped back usb cable and just plug it into a regular charger 5v at 1-2a.
But i just use binder clips to hold down contact between the wire and my silver now, more “hillbilly” but works and i don’t have rusty alligator clips
5 Likes